Regulator Pressure Fuel

Fuel Pression Control for Flute Gold Series

regolatore di pressione

Compared to the adjustable regulator, this model also offers the advantage of having a ratio of 1/1,4. Here’s a quick example to explain better. CLASSIC SYMMETRICAL PETROL PRESSURE REGULATOR. INITIAL CALIBRATION PRESSURE OF THE PETROL 3 BAR + TURBINE BOOSTING PRESSURE 1 BAR = FINAL RESULT OF THE PETROL PRESSURE 4 BAR In this condition, if we need to send more fuel to the engine because the mix is weak, we need to adjust the pressure regulator and increase it just enough to reach the carburation at medium and high rates. If the carburation is on the other hand very weak, we need to increase the pressure regulator considerably, thus creating DIRTY carburation at low rates. (with obvious consequences of loss in torque, pollution, consumption and immediate deterioration of the catalyst) We therefore need to find a compromise and accept what we can do. Conclusion: dirty output at low rates, almost good at medium rates and limit weak conditions at high rates. This problem disappears with the ASYMMETRIC regulator with ratio of 1/1,4 because the increase percentage is asymmetrical with the turbine pressure. Example: INITIAL CALIBRATION PRESSURE OF THE PETROL- 3 BAR + TURBINE BOOSTING PRESSURE 1 BAR = (addition of 1,4 bar of petrol pressure) FINAL RESULT OF THE PETROL PRESSURE 4.4 BAR Not only is it asymmetric but it is also progressive, therefore the increase in pressure is proportional even from the low turbine pressures; each tenth of a bar of the turbine involves an increase of 1,4 tenths of a bar in the petrol pressure. It is also adjustable and also interchangeable with the original regulator, therefore it does not need to be modified to be able to install it. No awkward and dangerous piping filled with pressurised petrol to run around the engine bay.

MAXIMUM LOAD: 3 bar = 270 lh - 4 bar = 220 lh - 5 bar = 190 lh

Code to order : RPBG

Price: 190,00 Euro ( + VAT AND SHIPPING COST)


Fuel Pression Control for Flute Injection

regolatore in flauto

Fuel Pression Control The Fuel Pression Control serve short and simplify. Later we will call the with the Fuel Pression Control with an acronym: fpc. Your motor turns “thin”, that is insufficient of fuel, because one not precise reason or because they it is been born therefore gives. In this case if we assemble a fcp and we raise also a few the fuel pressure, immediately we have the power increments they are perceive also less expert. But if our motor turns very well carburation and we install the fpc, we don’t non avremo any improvement or if the motor turns lightly “fat” and we assemble a fcp, we have lose whether power and pair.


3 bar = 270 lh - 4 bar = 220 lh - 5 bar = 190 lh

Code to order RPB

Price: 160,00 Euro ( + VAT AND SHIPPING COST)

  • abarth
  • alfa romeo
  • audi
  • citroen
  • fiat
  • ford
  • jeep
  • lancia
  • mazda
  • Mercedes benz logo
  • mini
  • Mitsubishi
  • nissan-white
  • opel
  • peugeot
  • renault
  • seat
  • skoda
  • smart
  • subaru
  • toyota
  • volkswagen


Phone +39-02-6460031
Mobile +39-339-6455611 (Available on WhatsApp)    

Contact Us

banner suoni it new

We use cookies to make sure that our website works correctly. We also use cookies for some basic analytics, to help us improve the site. We won't place non-essential cookies unless you have given us permission to do so. Read More